Dual-Frequency Radar Wave-Inversion for Sub-Surface Material Characterization
0
🤔
Sign in to get full access
Overview
- Moisture estimation in soil and overlaying biomass is crucial for precision agriculture and wildfire risk assessment
- Radar signals can be used to measure moisture, but the layered structure of soil and biomass creates challenges
- This study investigated using a combination of high and low frequency radar signals to better characterize both the soil and biomass layers
Plain English Explanation
Knowing the moisture content of soil and the plant material (biomass) on top of it is very important for precision farming and predicting wildfires. Radar signals, which are like radio waves, can be used to measure this moisture. However, the layered structure of the soil and biomass makes it tricky to get accurate measurements.
In this study, the researchers tried using a combination of high and low frequency radar signals to better estimate the moisture in both the soil layer and the biomass layer on top. The idea is that each layer might be better characterized by one of the frequencies. By using both high and low frequency signals together, the researchers could get more consistent and accurate measurements of the moisture in both layers.
Technical Explanation
The researchers proposed a waveform inversion-based method to predict the dielectric permittivity, which is a proxy for moisture content, of the bottom soil layer and the top biomass layer from radar signals. They investigated whether using a combination of a higher and lower frequency radar would provide better results compared to using a single frequency.
The experiments showed that each layer was best characterized by one of the radar frequencies. However, for simultaneously predicting the permittivity of both layers, the most consistent results were achieved by inverting data from the combination of both high and low frequency radar signals. This approach showed better correlation with direct measurements of permittivity and reduced prediction errors.
Critical Analysis
The paper acknowledges that the layered structure of soil and biomass creates challenges for accurately estimating moisture content using radar signals alone. While the proposed waveform inversion method using dual-frequency radar shows promise, the authors note that further research is needed to fully optimize the technique and validate it across a wider range of soil and vegetation conditions.
Additionally, the study was conducted in a relatively controlled setting. Applying this approach in real-world precision agriculture or wildfire monitoring scenarios may present additional complexities that were not addressed. Further field testing would be valuable to understand the practical limitations and potential for this technique to be deployed at scale.
Conclusion
This research demonstrates that using a combination of high and low frequency radar signals can provide more reliable estimates of moisture content in layered soil and biomass environments, compared to single-frequency approaches. This has important implications for applications like precision farming and wildfire risk assessment, where accurate sub-surface moisture monitoring is crucial. While additional work is needed, this study represents a step forward in addressing the challenge of characterizing complex layered materials using remote sensing techniques.
This summary was produced with help from an AI and may contain inaccuracies - check out the links to read the original source documents!
Related Papers
🤔
0
Dual-Frequency Radar Wave-Inversion for Sub-Surface Material Characterization
Ishfaq Aziz, Elahe Soltanaghai, Adam Watts, Mohamad Alipour
Moisture estimation of sub-surface soil and the overlaying biomass layer is pivotal in precision agriculture and wildfire risk assessment. However, the characterization of layered material is nontrivial due to the radar penetration-resolution tradeoff. Here, a waveform inversion-based method was proposed for predicting the dielectric permittivity (as a moisture proxy) of the bottom soil layer and the top biomass layer from radar signals. Specifically, the use of a combination of a higher and a lower frequency radar compared to a single frequency in predicting the permittivity of both the soil and the overlaying layer was investigated in this study. The results show that each layer was best characterized via one of the frequencies. However, for the simultaneous prediction of both layers permittivity, the most consistent results were achieved by inversion of data from a combination of both frequencies, showing better correlation with in situ permittivity and reduced prediction errors.
Read more4/1/2024
👁️
0
Bayesian inversion of GPR waveforms for sub-surface material characterization: an uncertainty-aware retrieval of soil moisture and overlaying biomass properties
Ishfaq Aziz, Elahe Soltanaghai, Adam Watts, Mohamad Alipour
Accurate estimation of sub-surface properties such as moisture content and depth of soil and vegetation layers is crucial for applications spanning sub-surface condition monitoring, precision agriculture, and effective wildfire risk assessment. Soil in nature is often covered by overlaying vegetation and surface organic material, making its characterization challenging. In addition, the estimation of the properties of the overlaying layer is crucial for applications like wildfire risk assessment. This study thus proposes a Bayesian model-updating-based approach for ground penetrating radar (GPR) waveform inversion to predict moisture contents and depths of soil and overlaying material layer. Due to its high correlation with moisture contents, the dielectric permittivity of both layers were predicted with the proposed method, along with other parameters, including depth and electrical conductivity of layers. The proposed Bayesian model updating approach yields probabilistic estimates of these parameters that can provide information about the confidence and uncertainty related to the estimates. The methodology was evaluated for a diverse range of experimental data collected through laboratory and field investigations. Laboratory investigations included variations in soil moisture values, depth of the overlaying surface layer, and coarseness of its material. The field investigation included measurement of field soil moisture for sixteen days. The results demonstrated predictions consistent with time-domain reflectometry (TDR) measurements and conventional gravimetric tests. The depth of the surface layer could also be predicted with reasonable accuracy. The proposed method provides a promising approach for uncertainty-aware sub-surface parameter estimation that can enable decision-making for risk assessment across a wide range of applications.
Read more7/2/2024
0
MIS-ME: A Multi-modal Framework for Soil Moisture Estimation
Mohammed Rakib, Adil Aman Mohammed, D. Cole Diggins, Sumit Sharma, Jeff Michael Sadler, Tyson Ochsner, Arun Bagavathi
Soil moisture estimation is an important task to enable precision agriculture in creating optimal plans for irrigation, fertilization, and harvest. It is common to utilize statistical and machine learning models to estimate soil moisture from traditional data sources such as weather forecasts, soil properties, and crop properties. However, there is a growing interest in utilizing aerial and geospatial imagery to estimate soil moisture. Although these images capture high-resolution crop details, they are expensive to curate and challenging to interpret. Imagine, an AI-enhanced software tool that predicts soil moisture using visual cues captured by smartphones and statistical data given by weather forecasts. This work is a first step towards that goal of developing a multi-modal approach for soil moisture estimation. In particular, we curate a dataset consisting of real-world images taken from ground stations and their corresponding weather data. We also propose MIS-ME - Meteorological & Image based Soil Moisture Estimator, a multi-modal framework for soil moisture estimation. Our extensive analysis shows that MIS-ME achieves a MAPE of 10.14%, outperforming traditional unimodal approaches with a reduction of 3.25% in MAPE for meteorological data and 2.15% in MAPE for image data, highlighting the effectiveness of tailored multi-modal approaches. Our code and dataset will be available at https://github.com/OSU-Complex-Systems/MIS-ME.git.
Read more8/22/2024
0
Inversion-DeepONet: A Novel DeepONet-Based Network with Encoder-Decoder for Full Waveform Inversion
Zekai Guo, Lihui Chai, Shengjun Huang, Ye Li
Full waveform inversion (FWI) plays a crucial role in the field of geophysics. There has been lots of research about applying deep learning (DL) methods to FWI. The success of DL-FWI relies significantly on the quantity and diversity of the datasets. Nevertheless, existing FWI datasets, like OpenFWI, where sources have fixed locations or identical frequencies, provide limited information and do not represent the complex real-world scene. For instance, low frequencies help in resolving larger-scale structures. High frequencies allow for a more detailed subsurface features. %A single source frequency is insufficient to describe subsurface structural properties. We consider that simultaneously using sources with different frequencies, instead of performing inversion using low frequencies data and then gradually introducing higher frequencies data, has rationale and potential advantages. Hence, we develop three enhanced datasets based on OpenFWI where each source have varying locations, frequencies or both. Moreover, we propose a novel deep operator network (DeepONet) architecture Inversion-DeepONet for FWI. We utilize convolutional neural network (CNN) to extract the features from seismic data in branch net. Source parameters, such as locations and frequencies, are fed to trunk net. Then another CNN is employed as the decoder of DeepONet to reconstruct the velocity models more effectively. Through experiments, we confirm the superior performance on accuracy and generalization ability of our network, compared with existing data-driven FWI methods.
Read more8/16/2024